The Above Picture is Related Image of Another Journal
Components Requiring Assembly Product Assembly
California Institute of Technology, US has reference to this Academic Journal, Team Uno 11/11/04 Bunker Curnes Product Assembly Components Requiring Assembly Motor shell at middle joint Threaded rod in addition to collar Base Upper cap in addition to triangle Motor Shell Assembly Components: L-brackets 24 V DC motor 1/8? rivets ¬? bolts Fiberglass pole Delrin bearing Assembly: L-brackets are cut so that fit around motor in addition to then bolted so that the motor shell. More L-brackets are cut into smaller strips in addition to then placed perpendicularly so that the motor shell so that provide reinforcement. An aluminum plate is placed behind the L-brackets so that provide height in addition to a connection so that the fiberglass pole. The aluminum plates are then bolted into the fiberglass pole by connecting so that the delrin bearing on the interior.
Related University That Contributed for this Journal are Acknowledged in the above Image
Motor Shell Assembly Threaded Rod in addition to Collar Assembly Components: ?? – 10 aluminum threaded rod Delrin bearing (2) Thrust bearing alongside washer (2) Delrin collar Shoulder screw (2) Fiberglass pole Steel collar Assembly: The aluminum rod is milled down in the lathe in addition to connected so that the motor by the steel collar secured alongside set screws. Then, a delrin bearing is placed between the collar in addition to the threaded part of the rod alongside a thrust bearing in consideration of support. A similar bearing is placed at the top of the threaded rod. A delrin collar is drilled in addition to tapped so that be able so that move up in addition to down the rod until it hits the two bearings. Finally, set screws are placed in the side of the collar that allow an aluminum rod so that be securely connected so that the collar. Threaded Rod in addition to Collar Assembly
Base Assembly Components: Plywood sheets Fiberglass pole Delrin rod Sprockets Aluminum collar Delrin bearing Assembly: The base assembly is comprised of three layers of plywood that hold the other components. The top layer has a delrin bearing that holds the fiberglass pole in place. The bottom of the second layer has the bearing in consideration of the bottom of the fiberglass pole. In the bottom of the pole, a derlin rod is placed inside in addition to bolted in place. The delrin is then milled down so that be attached so that a sprocket that is below the bottom of the pole in between the first in addition to second layers. The sprocket is then connected so that the motor. Base Assembly Upper Cap in addition to Triangle Assembly Components: 2? diameter aluminum cylinder 1/8? sheet of aluminum ¬? bolts Umbrella Assembly: The aluminum cylinder is milled down so that allow a circular cap so that go over the fiberglass pole in addition to a straight slot in consideration of the aluminum triangle. Then, the sheet of aluminum is cut into a triangle alongside a strip attached going vertically. The umbrella is placed so that the umbrella shaft goes over the strip until it touches the top of the triangle. The umbrella is then bolted in place. A bolt is placed through the slot of the cap that allows the cap in addition to triangle so that be attached but still allows the triangle so that rotate.
Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis Ch 23 Catalysis
Cumbrowski, Carsten Host
Cumbrowski, Carsten is from United States and they belong to Host and work for KUAZ-FM in the AZ state United States got related to this Particular Article.
Journal Ratings by California Institute of Technology
This Particular Journal got reviewed and rated by and short form of this particular Institution is US and gave this Journal an Excellent Rating.